1. The sw-520D highly sensitive tilt sensor produced by our company is adopted.
2. Comparator output, clean signal, good waveform, strong driving ability, more
than 15mA.
3. potentiometer adjustment sensitivity
4. Operating voltage: 3.3V-12V
5. output form: digital switching output (0 and 1)
6. Fixed bolt holes are provided for convenient installation
7. Small board PCB size: 3.2cm x 1.7cem
8. Use a wide voltage LM393 comparator
Product use:
all kinds of Angle sensor, dumping sensor, tilt sensor, 2 output con
trol.
Directions for use:
1. The initial state of two outputs depends on the on-on and off-off of the tilt s
ensor. When the on-on, the green light is on and the low level is output; when th
e tilt sensor is off, the green light is off and the high level is output;
2. The tilt sensor is generally installed in the initial state of normal open state,
so that the tilt sensor is not in working state, prolong the service life;
3. The output end can be directly connected with the single chip microcomputer,
through the single chip microcomputer to detect the high and low level, so as to
detect the Angle change of the environment;
4. The output terminal can directly drive the relay module of the store, which can
form a high-power control Angle switch.
2 channels angle sensor module – the angle switch dumping sensor module – tilt sensor For Arduino
Περιγραφή
Product features:
1. The sw-520D highly sensitive tilt sensor produced by our company is adopted.
2. Comparator output, clean signal, good waveform, strong driving ability, more
than 15mA.
3. potentiometer adjustment sensitivity
4. Operating voltage: 3.3V-12V
5. output form: digital switching output (0 and 1)
6. Fixed bolt holes are provided for convenient installation
7. Small board PCB size: 3.2cm x 1.7cem
8. Use a wide voltage LM393 comparator
Product use:
all kinds of Angle sensor, dumping sensor, tilt sensor, 2 output con
trol.
Directions for use:
1. The initial state of two outputs depends on the on-on and off-off of the tilt s
ensor. When the on-on, the green light is on and the low level is output; when th
e tilt sensor is off, the green light is off and the high level is output;
2. The tilt sensor is generally installed in the initial state of normal open state,
so that the tilt sensor is not in working state, prolong the service life;
3. The output end can be directly connected with the single chip microcomputer,
through the single chip microcomputer to detect the high and low level, so as to
detect the Angle change of the environment;
4. The output terminal can directly drive the relay module of the store, which can
form a high-power control Angle switch.